SPEEDBIRD
Features

Everything in the box

Every edition has the same core: VM, WIN and PI. Here's what it does, with links to the spec where you want the details.

Adaptive SBP modem#

SBP is SPEEDBIRD's own HF/VHF/UHF ARQ modem. It goes from FST4-style frames that decode below −28 dB up to 16QAM OFDM at about 4.9 kbit/s.

11-level speed ladder

Four weak-signal tiers (SBP-FST4-120, FST4-60, FT8, FT4) and seven OFDM levels with LDPC codes, from BPSK rate 1/8 to 16QAM 3/4.

Jumps straight to the right speed

Sessions start at the level the start-up SNR supports and keep jumping to whatever the measured SNR allows. Losses walk them down as far as SBP-FT8.

1.8-second connects

The SBP-CALL start frame is a 1.79 s OFDM burst that decodes at about −12 dB. It falls back to FT4, then FT8, if nobody answers.

Remembers every peer

The last good level, SNR in both directions and failure margins are kept for each station and band. A reconnect within 15 minutes starts where you left off.

Steps around interference

A receiver can switch off jammed parts of the passband with an 8-subband carrier mask. In simulation, ROBUST and masked levels decode through an OFDM-like interferer 40 dB stronger.

Calling channel → clear data channel

Sessions start on the band's calling channel, then both stations move to the least-busy data channel they agree on. They fall back automatically if the move fails.

PING and TRACE

Check a station without a session, and get the SNR and level back for each hop. Inside a session these ride the ARQ without disturbing the transfer.

Capability negotiation

Stations exchange their enabled levels and use only levels both support. You can pin a level, limit the range or turn adaptation off for each radio.

SBP specification →

Multi-radio and bonding#

Run every radio you own at once: each gets its own modem, SSID and frequency.

Bonded transfers

Stripe one file across several SBP sessions on different radios and frequencies. Every radio carries part of the transfer in parallel. Chunks are reassembled at the far end by bond ID and checked with CRC-32. Start a bonded transfer from the Console.

One SSID per radio

K4MFC-6 on the IC-7610, K4MFC-7 on the IC-7300, K4MFC-8 on the IC-705. SPEEDBIRD won't let two radios share a callsign, because the mesh routes by it.

Cross-frequency relay

With radios on 7.084 and 14.084, a message heard on 40 m can leave on 20 m. It's on by default and you can switch it off.

Per-station frequencies

Map a callsign or pattern (W1ABC, W1*) to the frequency that reaches it. The modem moves there to send and comes home after 2 minutes idle.

Survives reboots

Running modems are saved and restored when the service starts, so an unattended station comes back on its own.

Managed channel plan

Calling and data channels for every band from 80 m to 440 MHz, chosen to stay legal and clear of FT8, beacons, Winlink and VARA channels. Each channel is marked for whether automatic control is allowed there.

Self-routing mesh#

The SBP mesh adds neighbour discovery, link-state routing and store-and-forward on top of ordinary SBP transfers. Nothing in it is encrypted, and every frame names its callsigns.

Routes by real throughput

Link cost is the estimated time to move 1 kB at the level each link's SNR supports, adjusted for link age and recent failures. Shortest paths are computed with Dijkstra.

Store-and-forward

No route yet? Messages wait and retry as routes change, for up to 24 hours. Failed links are marked down and traffic is rerouted around them.

End-to-end receipts and traceroute

Ask for a delivery receipt, or trace a path and get the SNR and level at every hop.

Your relay, your rules

Relay everything, an allow-list, or only your own traffic. Deny rules always win, and per-source size and rate limits apply. Your policy is advertised so others route around it.

Bulletins

Public QST/CQ messages flood the mesh once each, within the airtime cap.

Polite on the air

Routing traffic is capped at 2 % of airtime on HF and 5 % on VHF. It is only sent when the channel is idle and backs off when the channel is busy.

SBP Mesh specification →

Drop-in VARA replacement#

Keep Winlink Express, Pat and VarAC exactly as they are. SPEEDBIRD has a VARA HF-compatible TNC port for each radio, on the same port numbers. You can import your VARA, VarAC and Winlink Express settings in one step, and the session runs over SBP.

How the VARA replacement works →

SPEEDBIRD can also drive a real, licensed VARA modem over its TCP host interface, so you can reach VARA stations and RMS gateways from the same UI. See the VARA host client.

Pat, bundled and managed

The packages ship the official Pat client. SPEEDBIRD writes its configuration, starts and restarts it, and gives it a Winlink page in the UI.

Profiles

One Pat profile per modem: SBP on each radio, real VARA via the host client, or telnet to the Winlink CMS without RF.

Connect strings

Pat-style URLs and classic C W1AW-10 lines, with frequency, level and start-protocol options, e.g. sbp://ic7610/K4MFC-6?freq=7105.

Passwords stay private

Your Winlink password is stored in a 0600 file and never shown by the API or written to logs.

Winlink guide →

Meshtastic gateway#

Plug a Meshtastic node in over USB and connect it to an SBP radio with gateway rules.

Beacons and propagation#

Beacons guide →

Radios and audio#

LAN rigs

Icom radios over the network, ideal for the VM and Pi editions.

Sound-card rigs (Windows)

Icom CI-V, Kenwood, Yaesu, Elecraft or Hamlib rigctld; PTT by CAT, RTS, DTR or VOX; WASAPI, MME or DirectSound audio.

Auto RX gain

A slow AGC, or "set once and hold". It aims for a noise floor of about −40 dBFS and keeps peaks below −6 dBFS.

ALC-guided TX tuning

Two-tone bursts at the power you choose while it reads the radio's ALC meter. It keeps the highest level with zero ALC and stores it per band. It only runs when you click and confirm.

Safe transmit#

Every transmission goes through the TX arbiter. It checks the callsign (nothing keys as N0CALL), TX enable, the band, data mode, the power cap and timeouts, then logs the transmission. If it can't set the radio's RF power, it won't key.

SBP and the SBP mesh are published as §97.309(a)(4) requires. Nothing is encrypted; FEC, public scramblers and zlib are the only transformations. Every transmission carries your callsign in the clear.

Web UI and API#