SpeedBird-PI
The full SPEEDBIRD station on a Raspberry Pi. It's small and low-power, a good fit for a field kit, an EmComm go-box or a permanent mesh gateway that bridges HF and Meshtastic.
Install in one line#
$ curl -fsSL https://speedbird.io/install.sh | sudo bashThe script refuses 32-bit Raspberry Pi OS: SPEEDBIRD needs the 64-bit (arm64) image.
Same package as the VM edition#
SpeedBird-PI uses the same Linux package as SpeedBird-VM. The bundle carries arm64 Python wheels and the Pat Winlink client for arm64 and armhf, so installation works offline on supported Python versions.
sudo apt install ./speedbird_<version>_all.deb
Set station.callsign in /etc/speedbird/speedbird.yaml, then open https://<pi-address>/ from any device on your network.
Warning: the web UI has no authentication yet. Keep the Pi on a trusted network, which is easy to do in the field with its own Wi-Fi access point.
A natural mesh gateway#
- Meshtastic gateway: plug a Meshtastic node in over USB and add it on the Mesh page. SBP stations heard on HF show up on the Meshtastic map, and gateway rules can carry mesh text, positions and telemetry over HF.
- Cross-frequency SBP mesh: relay between radios on different bands, store-and-forward when a route is down.
- Beacons: time-sequenced beacons let a remote node report which bands are open.
Third-party traffic (§97.115). Mesh → HF relay stays off until you tick "Allow third-party traffic" on the rule. You are responsible for everything it relays.
Radios#
Like the VM edition, the Pi works best with a LAN-connected rig (for example an Icom over the network), because the SBP modem needs the radio's RX audio stream.
Next steps#
- Quick start: your first SBP contact and the SPEEDBIRD channel set
- Winlink: Winlink P2P over SBP with Pat
- Beacons: set up automatic beacons legally